Nordson 3100V Series Customer Product Manual

RTD-Style
Hot Melt
Hose
19
Connecting
the
New Hose
(contd)
5. Check for
low
pressure
leaks.
6.
Restore electrical
power
to the applicator.
7.
Let
the
unit and hose
reach operating
temperature.
8.
While slowly restoring air
pressure
to
the applicator and
guns,
check
for leakage. Retighten the
fittings as
necessary. lf no
leaks occur,
go
lo
Restarting the System.
NOTE: Severe
leaking between the
hose fitting and
either the
gun
fitting or the unit manifold
can indicate that
the O-ring(s)
are missing
or damaged.
9.
lf leaking occurs between
the hose
fitting and either the
gun
fitting
or
the unit
manifold, refer to
the applicator
technical manual
to
determine the
proper
fitting and/or
O-ring.
Then
do the
following:
a. Repeat
steps 1 through
4in Disconnecting
the Old
Hose.
b. Replace the fitting and/or
O-ring as
required.
c.
Repeat steps
2
through
9in Connecting the
New Hose.
Restarting the System
1
. Follow the start-up
procedures
in the applicator
technical
manual.
2.
Resume normaloperation.
@
2q)0 Nordson Corporation
All rights
resBrv6d
108232E
lssued
1/00
Manual
45-21

Nordson 3100V Series Specifications

General

Brand	Nordson
Model	3100V Series
Category	Melting Machines
Language	English