A2-18
Description
HEATERS
Key and Light
Pressing
the HEATERS
key turns
power
to the heaters
on and off.
The
heaters must
be turned on for
the unit to operate.
The HEATERS
light turns
on
when
this feature is active.
NOTE: lf the
system is set for
auto-energize heaters, the heaters are
automatically enabled
and the HEATERS light turns
on
when
the
POWER switch is
turned on.
CLOCK Key
and Light
Pressing the
CLOCK key turns
the
seven-day
clock on and off.
When
the clock is on, the system
is controlled by the settings for ENTER
STANDBY EXIT
STANDBY HEATERS
ON, and
HEATERS
OFF.
The CLOCK light
turns on when
this
feature
is active.
NOTE:
lf the clock
feature is enabled when
the
POWEH
switch is turned
otf, it will
automatically be enabled when
the switch is turned back on.
The CLOCK light will
turn on to show that
the clock feature
is
enabled.
PUMP Key
and Light
Pressing
the PUMP key
turns the
pump
on and off. The PUMP light
turns on when
this feature is
active.
NOTE: lf the
system is set for auto-energize
pump,
the
pump
turns on
either when the READY light
turns on or when the tank reaches the
temperature
you
have specified.
CLEAR FAULTS Key
Pressing
the CLEAR FAULTS key runs
a system test.
The
test
lasts
five
seconds
and
verifies
that the
problem
causing
a
system fault was
corrected. lf the
problem
was
corrected, the FAULT light in the System
Status area
of the operator
panel
will turn off
once the test
is completed.
lf
the
problem
was not corrected,
the
FAULT
light will stay on.
POWER
Switch
Pressing the POWER
switch turns
power
to the applicator on or off.
A2 EN-03-[3V-/I-AXXVI-2
41-3000v
lssued 2/99
GD999
Nordson Corporallon
All
righls reserved
To Next Page
Loading...
Need help?
General
