lnstallation
A3-47
8. System
Preparation
Filling the Tank with
Adhesive
An Example
of How to
Use
the
Seven-Day Clock Feature
At one company,
the
production
line runs
for two shifts each day and
shuts down
on
weekends.
Both shifts
shut down for 45 minutes twice
each day: once at 12:00
noon for lunch and again at
6:00
in the evening
for dinner. By
using the clock
feature, the company can have the unit
start and stop
by setting the clock feature
to
Put
the unit into
the
standby
mode
(ENTER
STANDBY)
at 12:00 P.M.
(INTEHVAL
1) and again
at 6:00
P.M.
(INTERVAL
2).
Take
the unit out of the
standby mode
(EXIT
STANDBY)
at 12:30 P.M.
(INTERVAL
1)
and at 6:30 P.M.
(INTERVAL
2),
allowing
15 minutes
for the
system to reach application
temperature.
Turn the heaters
on
(HEATERS
ON)
Monday
through Friday
30
minutes
before the start
of
the first
shift
(INTERVAL
1).
Turn the heaters
off
(HEATERS
OFF)
Monday
through
Friday
at the
end of the second shift
(INTERVAL
1).
NOTE: The clock
is not set for
Saturday
or
Sunday
when
the company
is
closed.
Follow
these
procedures
to flush
the system and
prepare
it for first
operation. This
part
of lhe lnstallation section
also includes
the
procedure
for
adjusting the
pressure
control valve
on
gear pump
units.
WARNING: Allow
only
qualified personnelto
operate the unit.
Use this
procedure
to fill the
tank with unmelted adhesive. Before
continuing, refer to
General Hot Melt Material Processing lnstructions
at
the beginning
of this manual.
1. lf
you
have
not already done
so,
program your
unit. Refer to System
Programming
Procedures in
this section.
2. Open the tank lid
a
a
a
a
@
2000
Nordson
Corporation
All rights reserved
41-3000y
lssued
5/00
ASEN-04-[3V-X-4XXVI-1 3r
To Next Page
Loading...
Need help?
General
