Nordson 3100V Series Customer Product Manual

Operation
A
4-11
5. Procedure
for
Changing
Adhesives
Contact
your
material
supplier about the compatibility
of the old and new
materials.
lf the old and
new adhesives
are compatible, add
the
new
adhesive
to the
tank. lf the new adhesive is
not compatible with
the old
one,
ask
your
supplier
for an acceptable flushing
material
to thoroughly
clean the
system.
Use this
procedure
to
clean the system before
changing to
an
adhesive
that is incompatible
with
the old one.
1. Ensure
that the unit is
at operating temperature.
WARNING:
System or material
pressurized.
Relieve
system
pressure.
Failure
to obserue may result
in serious
burns.
2. Relieve
system
pressure.
Referto Relieving
System Pressureinlhe
Maintenance
section of
this
manual.
3.
Drain
the unit
by
pumping
as
much
adhesive from
the tank as
possible
using
one of the following methods.
Method
of Draining
Description
Gun
Place
a suitable container
under each
gun
nozzle.
Remove each nozzle
from its
gun.
Turn on
the
pump
by
pressing
the PUMP
key and
pump
the adhesive out
through the
gun.
Manifold
Pump
the adhesive out
through the
manifold. Refer
to the filter flushing
procedure
for
your
filter in
lhe Maintenance
section of this manual.
Hose
Disconnect
a hose from its
gun.
Replace
the dust cover, which
was removed
during
installation,
on the hose
electrical
receptacle.
Position
the hose over
a
suitable
waste
container
and secure it.
Turn the
pump
on by
pressing
the PUMP
key
and
pump
the
adhesive out
through the
hose.
@O00 Nordson
Corporatlon
All rights
reserved
41-3000v
lssued 5/00
A4EN-06-[3V-A-AAXV]-1

Nordson 3100V Series Specifications

General

Brand	Nordson
Model	3100V Series
Category	Melting Machines
Language	English