Nordson 3100V Series Customer Product Manual

4
RTD-Style Hot Melt
Hose
lnstallation and
Electrical
Connections
Operation
a
WARNING: Failure to follow the
safety
procedures
can result in
injury or
death.
Allelectrical,
pneumatic, gas,
and hydraulic connections
and
installations of hot melt equipment may only be carried
out by
qualified personnel.
Be
sure to observe
installation
instructions for
components and accessories.
Equipment must be
properly grounded
and fused according to
its
rated current consumption
(see
lD
plate).
Cables which run outside the unit must
regularly be checked for
wear
or damage.
Power supply wire
gauge
and
insulation must be sutficient
to handle
rated
current
consumption.
Cables must never
be squeezed or
pinched.
Do not locate
cables or
hoses in high traffic areas.
The unit should be operated by
qualified personnel
in accordance
with
the
instructions
presented
in
this
document.
WARNING: Failure to follow the
safety
procedures
can result in
injury or death.
Never allow the unit to be
operated by
personnel
under the
influence
of substances
which reduce their reaction times,
or who are
not able
to operate the equipment
for
physical
reasons.
Prior to each start-up
of
the
unit, check
protection
and warning
devices
and
make sure they are fully
functional. Do not operate
the
unit if these devices are
not functioning
properly.
When
the removal of
safety equipment is required
for installation,
maintenance, or repair
of the unit, it must be
re-connected
immediately
upon
completion of the
work.
Prior
to start-up of
the unit, check to
make
sure
all safety
guards
and
safety
equipment
are in
place
and
functioning
properly.
a
a
a
a
a
a
a
a
Manual
45-21
1
08
232E
lssued 1/00
@
2000
Nordson Corporation
All rightrs reserued

Nordson 3100V Series Specifications

General

Brand	Nordson
Model	3100V Series
Category	Melting Machines
Language	English