lnstallation
A
3-43
6.
When
you
press
the Enter
key, the hour shown in the Multipurpose
display
stops flashing and the minutes
(3)
shown begin
flashing.
Check that the minutes
shown in the Multipurpose display
are
correct.
NOTE:
Once the clock is
set, all displays stop flashing.
To
Set Standby
and Heater Times
The
clock feature
turns the heaters on or off, or takes
the
unit into
and
out of
the standby mode at
preset
times. Using a seven-day, 24-hour
format,
the clock can store two
sets of times,
referred
to as intervals, for
each
day of the week. Each interval
can store four time settings:
.
one to enter
standby
.
one to exit standby
.
one
to turn the heaters on
.
one
to turn the heaters off
Follow
this
procedure
to set times for entering
and exiting standby and for
turning heaters
on and off. After
you
have
programmed
the clock, use
the
CLOCK key
to turn the clock feature on and off. The
CLOCK
light
turns
on when the clock feature
is active.
NOTE:
lf
you
have enabled
the
password
feature,
you
must
change the
number
in the Multipurpose
display
(500)
to the
password (321)
and
press
the
Enter
key before the
system
will
allow
you
to change the
clock
settings.
1.
See Figure A
3-25.
ln
the
System Setup
area,
press
the
Move Up
and Move Down
keys
(1)
until the light next
to the feature
you
wish to
set turns
on.
NOTE: When
you
select
any of the standby or heater on/off settings,
the unit selects
an
interval.
The INTERVAL 1 light
(2)
turns on as a
default.
Fig. A 3-25 Selecting
Standby and
Heater
Times
1. Move Up
and Move Down keys
2. INTERVAL
lights
Correct? Action:
Yes
Press the Enter key
to save the setting.
No
Press the
Up or
Down key
below the Multipurpose
display untilthe correct minutes
appear
on the display;
then
press
the Enter key
to save the setting.
O
c.oc^
O
@{**
ol1ffi*
o&ffi,*
O
@'**o"
O
@'*'*o*
12
'@
1
2
4103935
O
2000 Nordson
Corporation
All righls reserved
41-3000y
lssued
5/00
A3 EN-04-[3V-X-4XXVj-1
3
To Next Page
Loading...
Need help?
General
