Installation Procedure
J012/J013/J014 1-18 SM
 Keep the boxes so they can be used again to re-ship the printer. Before
shipping the printer, raise the scanner unit and push the shipping lock down to
the lock position. This locks the scanning mechanism so it cannot move during
handling and shipping.
1.3.5 INSTALL THE PRINT CARTRIDGES
 If ink gets on the skin, wash the affected area immediately with soap and cold
running water.
 If ink gets into the eyes, immediately flush the eyes with cold running water. If there
are signs of irritation or other problems, seek medical attention immediately.
 If ink is swallowed, drink a strong solution of cold water and table salt to induce
vomiting. Seek medical attention immediately.
 Ink is difficult to remove from fabric. Work carefully to avoid staining clothing when
performing routine maintenance or replacing cartridges.
 Always store print cartridges out of the reach of children.
1. Unpack the four cartridges provided with the printer.
 The "Starter" print cartridges provided for installation contain a limited supply of
ink. Make sure an additional set of print cartridges (purchased separately) is
available. Use only Ricoh Print Cartridges designed for use with this printer.
2. Open the right front cover.
3. Remove the Black Print cartridge from its package.
To Next Page
Loading...
Need help?
General
