Optimizing the Output Quali-
ty
Dealing with Material Thickness/Hardness (Softness) .......................................... 109
Overlap Cutting................................................................................. 109
Adjusting the Cutting-in Amount ............................................................ 112
Cutting the Corners Longer to Make It Easy to Detach Cutting Data (Over Cut)............ 113
Cutting Small Text and Complex Graphics Cleanly (Tangential)............................... 114
Smoothly Cutting Arcs and Other Curves (Smoothing) .......................................... 115
Preventing and Correcting Misaligned Cutting ................................................... 116
Keeping Material in Place and Stabilizing Cutting Accuracy............................. 116
Correcting Distance during Cutting Based on the Thickness of Material .............. 117
108 Optimizing the Output Quality
To Next Page
Loading...
Need help?
General