Setting the AAS Detection Mode
Normally the crop mark origin is set at the front right, facing the machine, but when crop marks are
set up using the AAS plug-in, you can specify the reading direction of the crop marks for the loaded
material.
Procedure
1. Press [MISC].
If material is loaded, press [ON/OFF LINE] to switch to offline mode.
2.
Press [▶] to display the screen shown below.
AAS detect mode
Select: OK:ENTER
3. Press [ENTER].
The current setting is displayed.
4. Press [▲] or [▼] to set the material detection mode.
Auto detection
Change: OK:ENTER
Detect upon rotating (by 180 degrees) according to the
orientation of the crop marks printed on the material
Reverse derection
Change: OK:ENTER
Detect from reverse direction (rear)
Forward derection
Change: OK:ENTER
Detect from front
5. Press [ENTER].
6. Press [ON/OFF LINE] to go back to the original screen.
MEMO
Default setting: [Auto detection]
RELATED LINKS
・ P. 62 "Automatic Detection of Material Feed Direction"
Automatic Detection of Material Feed Direction
Basic Printing and Cutting 63
To Next Page
Loading...
Need help?
General