Setting the Display Language and the Unit
This feature sets the language and units of measurement displayed on the display screen of the opera-
tion panel.
Procedure
1. Press [MISC].
If material is loaded, press [ON/OFF LINE] to switch to offline mode.
2. Set the display language.
(1) Press [▶] several times to display the screen shown below.
Select Language
Select: OK:ENTER
(2) Press [ENTER].
(3) Press [▲] or [▼] to select the display (menu) language.
(4) Press [ENTER] to confirm your entry.
3. Select the measurement unit for length.
(1) On the following screen, press [ENTER].
The screen is displayed with the selected language.
Select Unit
Select: OK:ENTER
(2) Press [▲] or [▼] to select the measurement unit for length.
(3) Press [ENTER] to confirm your entry.
4. Press [ON/OFF LINE] to go back to the original screen.
MEMO
Default setting:
• Display language: "English"
• Unit: "Metric"
Configuring and Viewing Environment Settings
16 Basic Settings and Operations
To Next Page
Loading...
Need help?
General