Are there overlapping lines?
The same data may have been copied, resulting in overlapping lines. Check the data.
Is the step count set to 1 in GreatCut-R?
If [Step count] is set to any value other than 1 under [Parameter] in the [Output to device] window
or [Layer Settings] window, the value is added to the number of cuts.
Check the [Output to device] window or [Layer Settings] window.
RELATED LINKS
・ P. 54 "Sending Cutting Jobs from GreatCut-R"
・ P. 99 "Configuring the Cutting Conditions Based on the Color of Cutting Lines"
The Machine Cuts the Same Area Twice
Output Quality Problems 159
To Next Page
Loading...
Need help?
General