Output Quality Problems
Printing and Cutting Are Misaligned ............................................................... 155
Is a thick material being used? ............................................................... 155
Is the sensor reading inaccurate? ............................................................ 155
Was the machine set to feed forward some amount of material before cutting? .... 155
Uncut Areas Remain or Cut Edges Are Not Clean ................................................ 156
Are the blade and blade holder securely mounted? ...................................... 156
Is the tip of the blade broken? ............................................................... 156
Is there any buildup of dust or material adhesive on the tip of the blade?........... 156
Is there any buildup of pieces of material or dust inside the blade holder? .......... 156
Is a thick material being used? ............................................................... 156
Are the blade force and cutting speed appropriate for the material being cut?..... 156
Is the amount of blade offset correct?...................................................... 156
Is the smoothing function set to [Disabled]? .............................................. 157
Is the blade protector damaged or deformed? ............................................ 157
The Machine Cuts the Carrier Paper ............................................................... 158
Are the blade tip adjustment and blade force appropriate for the material being cut?.
............................................................................................. 158
The Machine Cuts the Same Area Twice .......................................................... 159
Are there overlapping lines?.................................................................. 159
Is the step count set to 1 in GreatCut-R?................................................... 159
Misaligned Cutting Start and End Points .......................................................... 160
Was material feeding set?..................................................................... 160
154
Output Quality Problems
To Next Page
Loading...
Need help?
General