RELATED LINKS
・ P. 41 "Setting the Blade Offset"
Is the smoothing function set to [Disabled]?
To cut curves cleanly, set the smoothing function to [Enabled].
RELATED LINKS
・ P. 115 "Smoothly Cutting Arcs and Other Curves (Smoothing)"
Is the blade protector damaged or deformed?
If the blade protector is damaged, the material may not be cut correctly even if the machine's settings
and the installation of the blade and blade holder are all correct.
Replace the blade protector with the cutting pad supplied with this machine.
RELATED LINKS
・ P. 140 "Replacing the Blade Protector"
Uncut Areas Remain or Cut Edges Are Not Clean
Output Quality Problems 157
To Next Page
Loading...
Need help?
General