Roland Camm-1 GR2-540 User Manual

Other Cutting
Section Cutting..........................................................................................83
Setting Up Section Cutting......................................................................83
Cutting Perforated Lines ..............................................................................84
Setting Up Perforated Cutting Using the Printer Driver ....................................84
Setting Up Perforated Cutting with GreatCut-R .............................................86
Setting Up Perforated Cutting from the Operation Panel ..................................89
Cutting Multiple Sets of the Same Cutting Data ...................................................90
Duplicating Cutting Data with the AAS Plug-in ..............................................90
Duplicating Cutting Data with the GreatCut-R Plug-in .....................................90
Duplicating Cutting Data with GreatCut-R ...................................................92
Cutting the Cutting Data Repetitively on Operation Panel ................................94
82 Other Cutting

Roland Camm-1 GR2-540 Specifications

General

Brand	Roland
Model	Camm-1 GR2-540
Category	Cutter
Language	English