Line connection and line-side power components
3.7 Line filters
Booksize Power Units
68 Manual, (GH2), 04/2014, 6SL3097-4AC00-0BP6
Wideband Line Filter for Active Line Modules
3.7.4.1
Wideband Line Filters for Active Line Modules are mainly effective in the frequency range
from 150 kHz to 30 MHz; this is the range relevant to ensure compliance with the appropriate
standard. Wideband Line Filters can also effectively limit low-frequency line harmonics of
2 kHz and above; this protects additional loads connected to the same supply system
against disturbances and damage. As a result, these line filters have an extended function
range, with which a certain degree of independence can be achieved regarding the machine
installation location with generally unknown line supply parameters (e.g. line impedance).
Wideband Line Filters must always be used in conjunction with a line reactor for Active Line
Modules and not with an Active Interface Module.
Wideband Line Filters for Active Line Modules can achieve the interference voltage
categories listed below, when used in conjunction with the associated line reactor and an
EMC-compliant design (see also Chapter Combination options: Line reactors and line filters
(Page 136)).
● EN 61800-3 category C3 up to a total cable length
1)
of 350 m (shielded) for 16 kW,
36 kW, 55 kW, 80 kW, and 120 kW components
● EN 61800-3 category C2 up to a total cable length
1)
of 350 m (shielded) for 16 kW,
36 kW, 55 kW, 80 kW, and 120 kW components
1)
Maximum total cable length = Σ motor cables, line supply conductor from line filter to Line
1)
Module
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
