Commissioning
7
7.1 Basic safety instructions
7.1.1 Lever for position detection
WARNING
Lever for position detection
Danger of crushing and shearing with mounting kits which use a lever for position detection.
During commissioning and ongoing operation, severing or squeezing of limbs could occur as
a result of the lever. Risk of injury when working on control valves due to the high operating
force of the pneumatic actuator.
● Do not reach into the range of motion of the lever following mounting of the positioner and
mounting kit.
WARNING
Improper commissioning in hazardous areas
Device failure or risk of explosion in hazardous areas.
● Do not commission the device until it has been mounted completely and connected in
accordance with the information in Technical data (Page 281).
● Before commissioning take the effect on other devices in the system into account.
WARNING
Loss of explosion protection
Risk of explosion in hazardous areas if the device is open or not properly closed.
● Close the device as described in Installing/mounting (Page 39).
SIPART PS2 with PROFIBUS PA
Operating Instructions, 05/2019, A5E00127926-AC 107
To Next Page
Loading...
Need help?
General
