2.4 Conformity with European directives
The CE marking on the device shows conformity with the regulations of the following European
guidelines:
Electromagnetic com‐
patibility EMC
2014/30/EU
Directive of the European Parliament and of the Council on the har‐
monization of the laws of the Member States relating to electromag‐
netic compatibility.
Atmosphère explosi‐
ble
ATEX
2014/34/EU
Directive of the European Parliament and of the Council on the har‐
monization of the laws of the Member States relating to equipment and
protective systems intended for use in potentially explosive atmos‐
pheres.
2011/65/EU RoHS Directive of the European Parliament and of the Council on the re‐
striction of the use of certain hazardous substances in electrical and
electronic equipment
The directives applied can be found in the EU declaration of conformity for the associated
device.
See also
Certificates (http://www.siemens.com/processinstrumentation/certificates)
2.5 Improper device modifications
WARNING
Improper device modifications
Risk to personnel, system and environment can result from modifications to the device,
particularly in hazardous areas.
● Only carry out modifications that are described in the instructions for the device. Failure to
observe this requirement cancels the manufacturer's warranty and the product approvals.
Safety information
2.5 Improper device modifications
SIPART PS2 with PROFIBUS PA
20 Operating Instructions, 05/2019, A5E00127926-AC
To Next Page
Loading...
Need help?
General
