Siemens SIPROCESS GA700 User Manual

Description
3.6 Combined operation
Operating with the Local User Interface
46 Operating Manual, 06/2017, A5E31930478-05
Note
Authorization level
To execute the actions described below, you must be logged on with at least the
"Expert"
authorization level. You may have to log on again with the requested PIN.
Note
Alarm window
When you change the hardware of the device by replacing or adding modules or
components, the alarm window "Device configuration
changed" is displaye
d in the LUI during
re
-commissioning. To start the data synchronization, confirm the alarm by pressing
<ENTER>.
Depending on the specific application, parameter sets may have to be transmitted. The
message window "Transmit
parameters" is displayed. Informa
tion on the further procedure is
available in the tables below:
→
Case differentiations (Page 46)
→
Case differentiations (Page 46)
→
Case differentiations (Page 46)
→
Case differentiations (Page 46)
→
Case differentiations (Page 46)
3.6.4.3
Case differentiations
Table 3- 8 Plug & Measure - Commissioning
Case
Description
Data synchronization/Action
PM
AMx
New New Commissioning, PM without serial
number
Automatic data synchronization
1)
.
New New Commissioning, each module has a
serial number stored at the factory.
None of the modules has been con-
nected to another module before
Automatic data synchronization
1)
.
1)
Data synchronization: PM parameters are transferred to the AMx (x=1 or 2), parameters of the
AMx are transferred to the PM

Siemens SIPROCESS GA700 Specifications

General

Brand	Siemens
Model	SIPROCESS GA700
Category	Measuring Instruments
Language	English