Functions
6.8 [2.09] Settings > Inputs/outputs
Operating with the Local User Interface
152 Operating Manual, 06/2017, A5E31930478-05
5. Select function (pre-selection) and functions of the logic operation: "Function (pre-
selection)" and "Function" parameter fields.
Note
Assignment rule
The device excludes the
multiple assignment of functions. When you assign a function,
this function is no longer available for other digital inputs or for links to such inputs.
– Also use the information in Table 6-16 Digital inputs suppressed during function check
/ measuring protection (Page 143) when setting the function (pre-selection).
– By selecting a function (pre-selection) you also specify which functions can be
assigned to the logic operation.
Additional parameter fields are displayed according to the function (pre-selection) or
function.
6. Set additional parameter fields or check displayed values:
Additional param-
eter fields
Calibration pool
1
Diverse
1)
Check the parameter assignment of the calibration pool
The display refers to a specific calibration pool entry and includes: component(s), calibration
type, single/total calibration as well as the assigned measuring range.
Overview of digital inputs (Page 143)
[2.09.5] Digital outputs
6.8.5.1
Overview
Digital outputs on the basic device and optional module 1
Each basic device comes equipped with eight user-assignable digital outputs (relays) whose
output contacts can be switched. Optional module 1 makes 12 further digital outputs
available for which parameters can be set. The numbering of these digital outputs begins
again at 1.
To Next Page
Loading...
Need help?
General
