Yealink VC110 Administrator's Guide

Configuring Network
61
6. Select OK to reboot the endpoint immediately.
Configuring Network Settings Manually
If DHCP is disabled or the endpoint cannot obtain network settings from the DHCP server, you
need to configure them manually.
The following parameters should be configured for endpoints to establish network connectivity:
 IP Address: Configure the endpoint to use the assigned IP address.
 Subnet Mask: Enter the subnet mask address when the endpoint does not automatically
obtain the subnet mask.
 Gateway: A gateway is a network point that works as an entrance to another network.
 Primary DNS /Secondary DNS: Domain Name System (DNS) servers translates domain
names (for example: www.example.com), which can be easily memorized by humans, to
the numerical IP addresses (192.168.1.15) needed for the purpose of computer services
and devices worldwide.
Network parameters need to be configured manually on the endpoint are described below.
Parameter
Description
Configuration Method
Mode (IPv4/IPv6)
Configures the IP address mode.
Default: IPv4
Note: If you change this parameter,
the IP phone will reboot to make the
change take effect.
Remote Control
Web User Interface
Static IP
Enables or disables the endpoint to
use manually configured network
settings.
Default: Disabled
Note: If you change this parameter,
the endpoint will reboot to make the
change take effect.
Web User Interface
IP Address
Configures the IP address assigned
to the endpoint.
Default: Blank
Note: If you change this parameter,
the endpoint will reboot to make the
change take effect.
Remote Control
Web User Interface
Subnet Mask
Configures the subnet mask
assigned to the endpoint.
Default: Blank
Remote Control
Web User Interface

Yealink VC110 Specifications

General

Digital zoom	4 x
Focus adjustment	Auto
Video codecs	H.264, H.263
Maximum frame rate	30 fps
Supported video modes	720p, 1080p
Video formats supported	H.263, H.264
Supported graphics resolutions	352 x 288, 704 x 576, 1280 x 720 (HD 720), 1920 x 1080 (HD 1080)
Voice codecs	G.711a, G.722, G.722.1, G.722.1C
Line-in	Yes
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Pan range	-100 - 100 °
Tilt angle range	-30 - 30 °
Security algorithms	128-bit AES, HTTPS, SRTP, SSL/TLS
Ethernet LAN data rates	10, 100 Mbit/s
Supported network protocols	TCP/IP (IPv4), DHCP/ stastic IP, HTTP/ HTTPS, SRTP/TLS, IEEE802.1X, LLDP-MED, VLAN
Current	2 A
Power consumption (max)	30 W
Power consumption (typical)	24 W
Storage temperature (T-T)	-20 - 50 °C
Operating temperature (T-T)	10 - 40 °C
Operating relative humidity (H-H)	10 - 95 %

Weight and Dimensions

Depth	151.5 mm
Width	234.6 mm
Height	161 mm
Package depth	318 mm
Package width	432 mm
Package height	274 mm
Package weight	5900 g