EasyManuals Logo

Zontes ZT310-V User Manual

Zontes ZT310-V
111 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #96 background imageLoading...
Page #96 background image
11、REAR COVER COMPONENT 95
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1251112-001093 M6×16 Hexagon flange bolts (color zinc) 2
2 1274100-057095
flanging bushing φ6.2×φ8.5×3.5
φ14×1.5
2
3 1244100-052000
buffer rubber of flanging bushing
φ8.5×φ14×1
2
4 1224200-112000 ZT310 -V Electrical device box cover 1
5 1244100-072000 ZT250-R Battery straps 1
6 1184100-116000 ZT250 lithium battery 1
Fig.1 REAR COVER
COMPONENT
Electric device box cover component
PROCEDURE:
Electrical device box cover
Remove the bolt , remove the bushing and cushion rubber
Remove Electrical device box cover
Hold the metal clasp on the side near PKE and pull down, then remove the packing band.
Unplug the red anode protection cap of the main beam, and remove the battery's own nut with the sleeve.
Battery
Unscrew the black protective cap to remove the negative pole; then remove the red protective cap and remove
the positive pole; remove the battery. For reinstallation, connect the positive electrode first, then connect the
negative electrode. No parallel battery charging or ignition.
Remove the PKE cover and pull the charging connector out. Unplug the charger and plug it into a dedicated
lithium battery charger for manual charging. Pay attention to fire and ventilation during charging. Be careful not
to overcharge the charging time.
PROCEDURE:
Remove side covers and seat cushions in advance.
The material should be protected during discomponent to prevent damage to the paint.
Be careful not to overcharge the charging time. About the use and maintenance of the battery see the
instructions.
The battery voltage should be checked regularly. If it is lower than 12.5V, it is recommended to charge it in
time; it must not be overcharged; it should be taken out of storage for a long time without being used, and it
should be charged once a month.
Reassemble the battery or fuse, etc. Remember to remember to reset the EFI hardware: Turn on the key-
Ignition- 10 seconds After the ignition is turned off - After 10 seconds Turn on the ignition switch and repeat 2
times.
If the battery has reached the end of its useful life, it should be handed over to a qualified organization or a
dedicated recycling center for proper disposal. Discard it at will.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Zontes ZT310-V and is the answer not in the manual?

Zontes ZT310-V Specifications

General IconGeneral
BrandZontes
ModelZT310-V
CategoryMotorcycle
LanguageEnglish

Related product manuals