System Topology
Configuration Handbook, Autroprime Interactive Fire Detection System, 116-P-APRIME2-CONFIG/EGB, Rev. A, 2013-04-03,
Autronica Fire and Security AS
Page 111
7.6 Deactivate
This menu selection allows you to deactivate a selected detection
loop. If for example, a detection loop is not in use for any reason,
this detection loop can be deactivated.
From the Service Menu, perform the following:
Use the arrow down button to scroll downwards to
System Topology, then press Enter.
A list appears, including all loops and the panel bus.
Use the arrow button to select the detection loop you want to run
this command for.
Press the Function button
Use the arrow buttons to select Deactivate, then press Enter.
The selected detection loop will be deactivated (until it is manually
activated by running the Activate command).
7.7 Activate
This menu selection allows you to activate a selected detection loop
or the panel bus which is deactivated.
From the Service Menu, perform the following:
Use the arrow down button to scroll downwards to
System Topology, then press Enter.
A list appears, including all loops and the panel bus.
Use the arrow button to select the panel bus or the detection loop
you want to run this command for.
Press the Function button
Use the arrow buttons to select Activate, then press Enter.
The selected detection zone will be activated.
Note that deactivation of a loop is only allowed when the loop does
not contain any loop units.
Note that activation of a loop is only allowed when the loop does not
contain any loop units.
To Next Page
Loading...
Need help?
General
