Unit Configuration
Configuration Handbook, Autroprime Interactive Fire Detection System, 116-P-APRIME2-CONFIG/EGB, Rev. A, 2013-04-03,
Autronica Fire and Security AS
Page 85
5.12.2 Configure Properties for an Activation Group
The following properties can be changed:
the name of the local output
Activate group on Unit State:
meaning which alarm level the points within this activation group
will react to (pre-alarm, alarm, fault and disablement).
Activation Group Dependency:
meaning how many points within this activation group that must
be in alarm state before actions are initiated (1-5 and All).
From the Activation Groups Menu (5.12.1), perform the
following:
After selecting the Activation Group in question by means of the
arrow down/up buttons, press Enter twice.
Type a new Name, or accept the existing one by pressing the
arrow down button.
Press Enter, then use the left or right arrow button to select the
desired unit state (pre-alarm, alarm, fault and disablement), then
press Enter.
Use the left or right arrow button to determine how many points
within this activation group that must be in alarm state before
actions are initiated (1-5 and All).
To confirm the setting, press Enter once more.
5.12.3 Connect to Output
This menu allows you to connect a selected Activation Group to an
output.
From the Activation Groups Menu (5.12.1), perform the
following:
After pressing the Function button for the selected activation
group(s), select Connect to Output (the first menu selection), then
press Enter.
A list of all available outputs will appear in the display.
Use the arrow up/down button to select the output that
is to be connected to the selected Activation Group, then press
Enter.
To confirm the setting, press Enter once more.
To Next Page
Loading...
Need help?
General
