Autronica Autroprime 2 User Manual

Loop Operation
Configuration Handbook, Autroprime Interactive Fire Detection System, 116-P-APRIME2-CONFIG/EGB, Rev. A, 2013-04-03,
Autronica Fire and Security AS
Page 32
4.6 Show Low Current Units
The command allows you to identify low current loop units (100mA,
150mA, 200mA and 250mA) that are not intended to be on a high
current loop (300mA, 350mA and 400mA).
An attempt to increase the loop current to 300mA, 350mA or 400mA
for a selected detection loop (command: Service/Unit
Configuration/Detection Loop) will be rejected by the system if low
current units are on this detection loop (a fault message “Low
current loop unit detected” will tell you that there are one or several
low current loop units on the high current detection loop).
From the Service Menu, perform the following:
 After pressing the Function button for the selected detection
loop(s), use the arrow down button to select Show Low Current
Units, then press Enter twice.
All low current units are listed.


Autronica Autroprime 2 Specifications

General

Brand	Autronica
Model	Autroprime 2
Category	Measuring Instruments
Language	English