Unit Configuration
Configuration Handbook, Autroprime Interactive Fire Detection System, 116-P-APRIME2-CONFIG/EGB, Rev. A, 2013-04-03,
Autronica Fire and Security AS
Page 75
5.9.3 Connect to Output
This menu allows you to connect a selected local input to an output.
From the Local Inputs Menu (5.9.1), perform the following:
After pressing the Function button for the selected local input(s),
select Connect to Output (the first menu selection), then press
Enter.
A list of all available outputs will appear in the display.
Use the arrow up/down button to select the output that
is to be connected to the selected local input, then press Enter.
To confirm the setting, press Enter once more.
5.9.4 Connect to Alarm Zone
This menu allows you to connect a selected local input to an alarm
zone.
From the Local Inputs Menu (5.9.1), perform the following:
After pressing the Function button for the selected local input(s),
use the arrow down button to scroll downwards to Connect to
Alarm Zone, then press Enter.
A list of all available alarm zones will appear in the display.
Use the arrow up/down button to select the alarm zone that
is to be connected to the selected local input, then press Enter.
To confirm the setting, press Enter once more.
5.9.5 Disconnect from Output
This menu allows you to disconnect a selected local input from an
existing output.
From the Local Inputs Menu (5.9.1), perform the following:
After pressing the Function button for the selected local input(s),
use the arrow down button to scroll downwards to
Disconnect from Output, then press Enter.
In the display you will now see a list of all outputs that are connected
to the selected local input.
To disconnect the selected local input from an output, use the
arrow down button to select the output, then press
Enter.
To confirm the setting, press Enter once more.
To Next Page
Loading...
Need help?
General
