Autronica Autroprime 2 User Manual

Unit Configuration
Configuration Handbook, Autroprime Interactive Fire Detection System, 116-P-APRIME2-CONFIG/EGB, Rev. A, 2013-04-03,
Autronica Fire and Security AS
Page 89
5.13.4 ESPA
This menu selection includes the following submenus:
 Configure Settings (chapter 5.13.4.1)
 Configure Events (chapter 5.13.4.2)
 Configure Receivers (chapter 5.13.4.3)
 Send Test Event (chapter 5.13.4.4)
Note that ESPA always requires the use of the serial port.
5.13.4.1 Configure Settings
This menu selection allows you to configure ESPA settings.
From the External Interfaces Menu (5.13.1), perform the
following:
 Use the arrow down button to select ESPA, then press Enter.
 Select Configure Settings (the uppermost menu), then press
Enter twice.
 Type a new Name, or accept the existing one by pressing the
arrow down button.
 Press Enter, use the arrow left/right buttons to select the port
(not in use or serial), then press Enter.

 Use the arrow left/right buttons to select whether you want to
restore factory settings or not (No/Yes), then press Enter.
o If No is selected, the next menu selection will be shown and
all following values must be selected.
o If Yes is selected, default values will be used.
 Use the arrow left/right buttons to select the display size (default
128), then press Enter.
 Use the arrow left/right buttons to select the line length
(default 12), then press Enter.
 Use the arrow left/right buttons to select the alphabet type (7 bits,
8 bits, or GSM), then press Enter.
 Use the arrow left/right buttons to select the fault detail (Yes/No),
then press Enter.
 Use the arrow left/right buttons to select whether you want to
prepare for a startup message, then press Enter.
 To confirm the settings, press Enter once more.


Autronica Autroprime 2 Specifications

General

Brand	Autronica
Model	Autroprime 2
Category	Measuring Instruments
Language	English