Configuration Examples
Configuration Handbook, Autroprime Interactive Fire Detection System, 116-P-APRIME2-CONFIG/EGB, Rev. A, 2013-04-03,
Autronica Fire and Security AS
Page 124
9.2.7 Add a Site-specific Name to each Point (if needed)
From the Service Menu, perform the following:
Use the arrow down button to scroll downwards to
Unit Configuration, then press Enter.
Use the arrow down button to scroll downwards to Points.
Select the first point A1001 that is to be added a site-specific
name, then press Enter twice.
Type space and the name CANTEEN after the address,
for example, A1001 CANTEEN, then press Enter.
As all other properties use the default settings in this example,
simply press Enter or the arrow down button a number of times
(depending on the type of detector) to accept the settings.
Press Enter to confirm the settings (Accept).
Use the arrow down button to select the next point that is to be
added a site-specific name.
Repeat the procedure for each point according to the list below:
A1001 CANTEEN
A1002 CANTEEN
A1003 CANTEEN
A1004 SALES OFFICE
A1005 SALES OFFICE
A1006 CORRIDOR SOUTH
A1007 CORRIDOR SOUTH
A1008 Manual Call Point CORRIDOR SOUTH
To Next Page
Loading...
Need help?
General
