Unit Configuration
Configuration Handbook, Autroprime Interactive Fire Detection System, 116-P-APRIME2-CONFIG/EGB, Rev. A, 2013-04-03,
Autronica Fire and Security AS
Page 52
5.5.2 Configure Properties for a Fire Alarm Device
The following properties can be changed:
name of a Fire Alarm Device (FAD)
the “unit function” for local outputs that are assigned the unit
function Fire Alarm Device (FAD). (Refer to the Local Outputs
menu).
From the Fire Alarm Devices Menu (5.5.1), perform the
following:
After selecting the FAD in question by means of the arrow
down/up buttons, press Enter twice.
Type a new Name and press Enter, or accept the existing one by
pressing the arrow down button.
To confirm the setting, press Enter once more.
If a local output (that is assigned unit function FAD) is selected,
and not a FAD, use the arrow left/right buttons to select among
the following unit functions:
o Fire Alarm Device
o General Output
o RESET Out
o Silence Alarm Output
o Silence Out
o Small Alarm Output
o FWRE
o FARE
Press Enter.
To confirm the setting, press Enter once more.
5.5.3 Move to Alarm Zone
This menu allows you to connect a selected Fire Alarm Device to an
existing alarm zone or create a new alarm zone, and at the same
time connect the new alarm zone to the Fire Alarm Device.
From the Fire Alarm Devices Menu (5.5.1), perform the
following:
After pressing the Function button for the selected FAD(s), select
Move to Alarm Zone (the first menu selection), then press Enter.
Use the arrow button to select an existing alarm zone, or select
the menu Create New Alarm Zone.
o If an existing alarm zone is selected, press Enter twice to
connect the detection zone to this alarm zone.
o If a new alarm zone is to be created, select Create New
Alarm Zone, press Enter twice, type the name, then press
Enter.
o Use the left/right arrow buttons to select the Parent Alarm
Zone”, then press Enter twice to confirm.
To Next Page
Loading...
Need help?
General
