Unit Configuration
Configuration Handbook, Autroprime Interactive Fire Detection System, 116-P-APRIME2-CONFIG/EGB, Rev. A, 2013-04-03,
Autronica Fire and Security AS
Page 54
5.6 Loop Outputs
5.6.1 Accessing the Menu
From the Service Menu, perform the following:
Use the arrow down button to scroll downwards to
Unit Configuration, then press Enter.
Use the arrow down button to select Loop Outputs, then
press Enter once more.
Use the arrow up/down buttons to select the Loop Output
that is to be configured (if any).
To view or change properties for the selected Loop Output, refer
to Configure Properties for a Loop Output (chapter 5.6.2).
To access available functions for a selected loop output, press
the Function button
, or use, if necessary, the multiselect
feature to select several loop outputs by pressing the Select
button
to mark the loop outputs that are to be configured,
and then press the Function button .
The following menu selections will appear:
(Menu selections not applicable to FAD, FARE and FWRE):
o Connect to Output (chapter 0)
o Connect to Activation Group (chapter 5.6.4)
o Disconnect from Output (chapter 5.6.5)
o Disconnect from Activation Group (chapter 5.6.6)
o Show Activating Detection Zones (chapter 5.6.7)
o Show Activating Points (chapter 5.6.8)
o Show Activating Inputs (chapter 5.6.9)
o Show Activating Groups (chapter 5.6.10)
o Show Activating Outputs (chapter 5.6.11)
(Menu selection applies to FAD only):
o Move to Alarm Zone
(Menu selection not applicable to FARE, FWRE):
o Show Connected Units (chapter 5.6.12)
Scroll with the arrow up/down buttons to select the desired menu,
then follow the instructions in the relevant chapter.
To Next Page
Loading...
Need help?
General
