Digi IX14 User Manual

IX14 User Guide
10
Configuration and management
Review IX14 default settings 34
Change the default password for the admin user 34
Configuration methods 36
Using Digi Remote Manager 37
Access Digi Remote Manager 37
Using the web interface 37
Log out of the web interface 38
Use the local RESTAPI to configure the IX14 device 38
Use the GETmethod to return device configuration information 39
Use the POST method to modify device configuration parameters and list arrays 41
Use the DELETE method to remove items from a list array 41
Using the command line 43
Access the command line interface 43
Log in to the command line interface 43
Exit the command line interface 44
Initial configuration
Configure cellular modem APNs 47
Change the default LAN subnet 51
Change the LAN address type 52
Configure SIM PIN 54
Configure system settings 54
Enable or disable Bluetooth service 61
Interfaces
Wireless Wide Area Networks (WWANs) 66
Configure SureLink active recovery to detect modem failures 66
Configure the device to reboot when a failure is detected 76
Disable SureLink 84
Using cellular modems in a Wireless WAN (WWAN) 88
Configure a Wireless Wide Area Network (WWAN) 105
Show WWAN status and statistics 114
Delete a WWAN. 116
Local Area Networks (LANs) 119
About Local Area Networks (LANs) 120
Configure a LAN 120
Show LAN status and statistics 127
Delete a LAN 129
DHCP servers 131
Create a Virtual LAN (VLAN) route 147
Show Surelink status and statistics 149
Show Surelink status for all interfaces 149
Show Surelink status for a specific interface 149
Show Surelink status for all IPsec tunnels 150
Show Surelink status for a specific IPsec tunnel 150
Show Surelink status for all OpenVPN clients 151
Show Surelink status for a specific OpenVPN client 151
Serial port 153
Default serial port configuration 153
Serial mode options 153

Digi IX14 Specifications

General

Brand	Digi
Model	IX14
Category	Network Router
Language	English