Configuration and management Using the command line
IX14 User Guide
43
Using the command line
The Digi IX14 device provides a command-line interface that you can use to configure the device,
display status and statistics, update firmware, and manage device files.
See Command line interface for detailed instructions on using the command line interface and see
Command line reference for information on available commands.
Access the command line interface
You can access the IX14 command line interface using an SSH connection, a telnet connection, or a
serial connection. You can use an open-source terminal software, such as PuTTY or TeraTerm, to
access the device through one of these mechanisms.
You can also access the command line interface in the WebUI by using the Terminal, or the Digi
Remote Manager by using the Console.
To access the command line, your device must be configured to allow access, and you must log in as
a user who has been configured for the appropriate access. For further information about configuring
access to these services, see:
n
Serial: Serial port
n
WebUI: Configure the web administration service
n
SSH: Configure SSHaccess
n
Telnet: Configure telnet access
Log in to the command line interface
Command line
1. Connect to the IX14 device by using a serial connection, SSH or telnet, or the Terminal in the
WebUI or the Console in the Digi Remote Manager. See Access the command line interface for
more information.
n
For serial connections, the default configuration is:
l
115200 baud rate
l
8 data bits
l
no parity
l
1 stop bit
l
no flow control
n
For SSH and telnet connections, the default IP address of the device is 192.168.2.1 on
the WAN/ETH1 .
2. At the login prompt, enter the username and password of a user with Admin access.
Note If your device was manufactured prior to firmware version 19.11.x, the default user for
logging into the device may be root, rather than admin.
To Next Page
Loading...
Need help?
General
