Configuration and management Review IX14 default settings
IX14 User Guide
34
Review IX14 default settings
The following table lists factory default settings for the IX14.
Central
management
n
Digi Remote Manager enabled as the central management service.
Interface
priorities
n
Modem (cellular) is WAN interface with metric of 3.
n
LAN (Ethernet) with metric of 5.
Modem
configuration
n
SIM failover after 5 attempts.
Network
settings
n
LAN subnet of 192.168.2.1/24.
n
DHCP enabled.
n
Source NAT enabled (outbound traffic).
Security
policies
n
Packet filtering allows all outbound traffic.
n
SSH, web admin, and local admin access enabled.
Services
n
Bluetooth service enabled to allow the Digi Remote Manager mobile app
to automatically register using the QR code on the device label. You can
disable Bluetooth service after the device is provisioned.
Monitoring
n
Device heath metrics uploaded to Digi Remote Manager at 60 minute
interval.
Change the default password for the admin user
The unique, factory-assigned password for the default admin user account is printed on the bottom
label of the device and on the loose label included in the package.
If you erase the device configuration or reset the device to factory defaults, the password for the
admin user will revert to the original, factory-assigned default password.
Note If your device was manufactured prior to the release of firmware version 19.11.x, the default
user name may be root.
To change the default password for the admin user:
WebUI
1. Log into the IX14 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
To Next Page
Loading...
Need help?
General
