Digi IX14 User Manual

Virtual Private Networks (VPN) L2TPv3 Ethernet
IX14 User Guide
655
3. To display details about a specific tunnel:
> show l2tp lns name lns_test2
lns_test2 L2TP Access Concentrator Status
------------------------------------
Enabled : true
Status : pending
>
4. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
L2TPv3 Ethernet
Your IX14 device supports Layer 2 Tunneling Protocol Version 3 (L2TPv3) static unmanaged Ethernet
tunnels.
Configure an L2TPv3 tunnel
Your IX14 device supports Layer 2 Tunneling Protocol Version 3 (L2TPv3) static unmanaged Ethernet
tunnels.
Required configuration items
n
Aname for the L2TPv3 tunnel.
n
Enable the tunnel.
n
The remote endpoint IP address.
n
The local endpoint IP address.
n
The session ID.
n
The peer session ID.
Additional configuration items
n
Encapsulation type. If UDP is selected:
l
The IDfor the tunnel.
l
The IDof the peer's tunnel.
l
Determine whether to enable UDP checksum.
n
The session cookie.
n
The peer session cookie.
n
The Layer2SpecificHeader type.
n
The Sequence numbering control.
WebUI

Digi IX14 Specifications

General

Brand	Digi
Model	IX14
Category	Network Router
Language	English