EasyManuals Logo
Home>Digi>Network Router>IX14

Digi IX14 User Manual

Digi IX14
828 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #131 background imageLoading...
Page #131 background image
Interfaces Local Area Networks (LANs)
IX14 User Guide
131
DHCP servers
You can enable DHCP on your IX14 device to assign IP addresses to clients, using either:
n
The DHCP server for the device's local network, which assigns IP addresses to clients on the
device's local network. Addresses are assigned from a specified pool of IPaddresses. For a
local network, the device uses the DHCP server that has the IPaddress pool in the same
IPsubnet as the local network.
When a host receives an IPconfiguration, the configuration is valid for a particular amount of
time, known as the lease time. After this lease time expires, the configuration must be
renewed. The host renews the lease time automatically.
n
A DHCP relay server, which forwards DHCP requests from clients to a DHCP server that is
running on a separate device.
Configure a DHCP server
Note These instructions assume you are configuring the device to use its local DHCP server. For
instructions about configuring the device to use a DHCP relay server, see Configure DHCP relay.
Required configuration items
n
Enable the DHCP server.
Additional configuration items
n
The lease address pool: the range of IPaddresses issued by the DHCPserver to clients.
n
Lease time: The length, in minutes, of the leases issued by the DHCP server.
n
The Maximum Transmission Units (MTU).
n
The domain name suffix appended to host names.
n
The IPgateway address given to clients.
n
The IPaddresses of the preferred and alternate Domain Name Server (DNS), NTP servers, and
WINS severs that are given to clients.
n
The TFTP server name.
n
The filepath and name of the bootfile on the TFTP server.
n
Custom DHCP options. See Configure DHCP options for information about custom DHCP
options.
n
Static leases. See Map static IP addresses to hosts for information about static leases.
WebUI
1. Log into the IX14 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Digi IX14 and is the answer not in the manual?

Digi IX14 Specifications

General IconGeneral
BrandDigi
ModelIX14
CategoryNetwork Router
LanguageEnglish

Related product manuals