System administration Configuration files
IX14 User Guide
300
1. Log into the IX14 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Make any necessary configuration changes.
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Save configuration to a file
You can save your IX14 device's configuration to a file and use this file to restore the configuration,
either to the same device or to similar devices.
WebUI
This procedure creates a binary archive file containing the device's configuration, certificates and
keys, and other information.
1. Log into the IX14 WebUI as a user with Admin access.
2. On the main menu, click System. Under Configuration, click Configuration Maintenance.
The Configuration Maintenance windows is displayed.
To Next Page
Loading...
Need help?
General
