Diagnostics Perform a speedtest
IX14 User Guide
670
Perform a speedtest
To perform a speedtest:
Command line
1. Log into the IX14 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the speedtest command to generate the report:
> speedtest host
where host is the hostname or IP address of a speedtest host. For example:
> speedtest speedtest.accns.com
Tx (upload) average: 50.1110 Mbps
Tx latency: 31.45 ms
Rx (download) average: 44.7588 Mbps
Rx latency: 30.05 ms
>
3. To output the result in json format, use the output parameter:
> speedtest host output json
{"tx_avg": "51.8510", "tx_avg_units": "Mbps", "tx_latency": "31.07",
"tx_latency_units": "ms", "rx_avg": "39.5770", "rx_avg_units": "Mbps",
"rx_latency": "34.19", "rx_latency_units": "ms" }
>
4. To change the size of the speedtest packet, use the size parameter:
> speedtest host size int
5. By default, the speedtest uses nuttcp for the mode. You can change this to iperf with the mode
parameter:
> speedtest host mode iperf
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Generate a support report
To generate and download a support report:
WebUI
To Next Page
Loading...
Need help?
General
