Virtual Private Networks (VPN) OpenVPN
IX14 User Guide
599
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure an OpenVPN client without using an .ovpn file
Required configuration items
n
Enable the OpenVPN client.
The OpenVPN client is enabled by default.
n
The mode used by the OpenVPN server, either routing (TUN), or bridging (TAP).
n
The firewall zone to be used by the OpenVPN client.
n
The IP address of the OpenVPN server.
n
Certificates and keys:
l
The CA certificate (usually in a ca.crt file).
l
The Public key (for example, client.crt)
l
The Private key (for example, client.key).
Additional configuration items
n
The route metric for the OpenVPN client.
n
The login credentials for the OpenVPN client, if configured on the OpenVPN server.
n
Additional OpenVPN parameters.
See Configure SureLink active recovery for OpenVPN for information about OpenVPN active recovery.
WebUI
1. Log into the IX14 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
To Next Page
Loading...
Need help?
General
