Command line interface Configuration mode
IX14 User Guide
786
4. Lastly, display the allowed values and other information for the enable parameter:
> config service ssh enable ?
Enable: Enable the service.
Format: true, false, yes, no, 1, 0
Default value: true
Current value: true
> config service ssh enable
Configuration mode
Configuration mode allows you to perform multiple configuration tasks and validate the changes prior
to saving them. You can cancel all changes without saving them at any time. Configuration changes
do not take effect until the configuration is saved.
Enable configuration mode
To enable configuration mode, at the root prompt, enter the config command without any
parameters:
> config
(config)>
When the command line is in configuration mode, the prompt will change to include (config), to
indicate that you are currently in configuration mode.
Enter configuration commands in configuration mode
There are two ways to enter configuration commands while in configuration mode:
n
Enter the full command string from the config prompt.
For example, to disable the ssh service by entering the full command string at the config
prompt:
(config)> service ssh enable false
(config)>
n
Execute commands by moving through the configuration schema.
For example, to disable the ssh service by moving through the configuration and then
executing the enable false command:
1. At the config prompt, enter service to move to the service node:
(config)> service
(config service)>
2. Enter ssh to move to the ssh node:
(config service)> ssh
(config service ssh)>
To Next Page
Loading...
Need help?
General
