To Next Page

To Previous Page

Services Simple Network Management Protocol (SNMP)

IX14 User Guide

359

(config)> service snmp enable 2c true

(config)>

13. Save the configuration and apply the change:

(config)> save

Configuration saved.

14. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Download MIBs

This procedure is available from the WebUI only.

Required configuration items

Enable SNMP.

To download a .zip archive of the SNMP MIBs supported by this device:

WebUI

1. Log into the IX14 WebUI as a user with Admin access.

2. Enable SNMP.

See Configure Simple Network Management Protocol (SNMP) for information about enabling

and configuring SNMP support on the IX14 device.

3. On the main menu, click Status. Under Services, click SNMP.

Note If you have recently enabled SNMP and the SNMP option is not visible, refresh your

browser.

The SNMP page is displayed.

4. Click Download.

Digi IX14 User Manual

Questions and Answers: