Digi IX14 User Manual

File system Move or rename a file or directory
IX14 User Guide
761
n
To copy the file /etc/config/accns.json to a file named backup_cfg.json in a directory
named /etc/config/test, enter the following:
> cp /etc/config/accns.json /etc/config/test/backup_cfg.json
>
n
To copy a directory named /etc/config/test to /opt:
> cp /etc/config/test/ /opt/
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Move or rename a file or directory
This procedure is not available through the WebUI. To move or rename a file or directory by using the
Admin CLI, use the mv command.
Command line
To rename a file named test.py in /etc/config/scripts to final.py:
1. Log into the IX14 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the Admin CLI prompt, type:
> mv /etc/config/scripts/test.py /etc/config/scripts/final.py
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
To move test.py from /etc/config/scripts to /opt:
1. Log into the IX14 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the Admin CLI prompt, type:
> mv /etc/config/scripts/test.py /opt/
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Digi IX14 Specifications

General

Brand	Digi
Model	IX14
Category	Network Router
Language	English