Services Use the iPerf service
IX14 User Guide
423
Additional Configuration
--------------------------------------------------------
-----------------------
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config)>
Repeat this step to list additional firewall zones.
5. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Use the iPerf service
Your IX14 device includes an iPerf3 server that you can use to test the performance of your network.
iPerf3 is a command-line tool that measures the maximum network throughput an interface can
handle. This is useful when diagnosing network speed issues, to determine, for example, whether a
cellular connection is providing expected throughput.
The IX14 implementation of iPerf3 supports testing with both TCP and UDP.
Note Using iPerf clients that are at a version earlier than iPerf3 to connect to the IX14 device's iPerf3
server may result in unpredictable results. As a result, Digi recommends using an iPerf client at
version 3 or newer to connect to the IX14 device's iPerf3 server.
Required configuration items
n
Enable the iPerf server on the IX14 device.
n
An iPerf3 client installed on a remote host. iPerf3 software can be downloaded at
https://iperf.fr/iperf-download.php.
Additional configuration Items
n
The port that the IX14 device's iPerf server will use to listen for incoming connections.
n
The access control list for the iPerf server.
To Next Page
Loading...
Need help?
General
