GE RAFT VOLUSON™ P8/VOLUSON™P6
DIRECTION 5775469, R
EVISION 3 DRAFT (JULY 19, 2018) BASIC SERVICE MANUAL
4-12 Section 4-5 - Backup and Restore Database, Preset Configurations and Images
Section 4-5
Backup and Restore Database, Preset Configurations and Images
1.) Press the F2 key on the control panel.
2.) In the “Utilities” menu select SYSTEM SETUP
to invoke the setup desktop on the screen.
3.) On the left side of the screen select BACKUP
and then click the SYSTEM CONFIGURATION tab.
The
SYSTEM CONFIGURATION page is subdivided in 2 main groups:
A.) Image Settings Only
• Section 4-5-1 "Save Small Backup (Scan Settings)" on page 4-13
• Section 4-5-2 "Load Small Backup (Scan Settings)" on page 4-14
B.) Full System Configuration
• Section 4-5-3 "Save Full System Configuration (Full Backup)" on page 4-17
• Section 4-5-4 "Load Full System Configuration (Full Backup)" on page 4-19
• Section 4-5-5 "Delete Full System Configuration (Full Backup)" on page 4-21
The Image Settings and/or Full System Configuration can be saved to the following destinations:
• D: partition of internal hard disk
• DVD/CD±R/RW
• Mapped Network Drive, see:
Section 3-12-2 "Wireless Network Configuration" on page 3-73
• Any other drive connected to the system (e.g.; USB-Stick or external hard disk drive)
Note:
This function is only available in the Full Backup utility.
For further details review: Section 3-5-9 on page 3-22
!! CAUTION:
It is recommended to Backup the Full System Configuration (Section 4-5-3 on page 4-17) and the
Image Archive (Section 4-5-6 on page 4-22) once a week.
Figure 4-11 System Setup - Backup - SYSTEM CONFIGURATION page
Image Settings only
Full System
Configuration
To Next Page
Loading...
Need help?
General
