GE DRAFT VOLUSON™ P8/VOLUSON™P6
DIRECTION 5775469, R
EVISION 3 DRAFT (JULY 19, 2018) BASIC SERVICE MANUAL
Chapter 3 - Setup Instructions 3-13
3-5-2 Connecting the Black & White Printer
1.) Power OFF/Shutdown the system as described in: Section 3-6-3 on page 3-28.
2.) Connect the Black & White printer according to correct connection scheme as described in
Figure 3-6 on page 3-14
NOTE: The Black & White printer should be connected to the USB2 port of the Voluson™ P8/Voluson™P6´s
PC-part.
3.) When all the cables are connected, press the Power ON switch on the Black & White printer.
4.) Power ON/Boot up the Voluson™ P8/Voluson™P6 system as described in Section 3-6-2 on page
3-25. All software drivers are pre-installed for the designated Black & White printer only.
5.) After physical connection to the Voluson™ P8/Voluson™P6 system, assign the printer to a remote
key (P1
, P2, and P3 ) as described in Section 3-7-8 "Remote Control Selection" on page 3-53.
6.) Verify the correct settings in the printer “Properties”, see: Section 3-7-7 "Adjustment of Printer
Settings" on page 3-49.
!! WARNING:
After each installation, the leakage currents have to be measured according to
IEC 60601-1 respectively UL 60601-1 and ANSI/AAMI ES60601-1.
To Next Page
Loading...
Need help?
General
