Honda TRX70 Fourtrax 1986 User Manual

SPARK ARRESTER CLEANING
i ~
Do not remove and install the sJHlrk Il"f!ster while the uhaust
pipe is hot.
Perform this operation in II wd l ventilated area. free from fire
hllUlrd.
Uu IIdequate eye pro/ntlon .
Remo ve the spa rk arrester bott and pull o ut the spark arrester.
Remove
any accumulated carbon from the spark arrester.
Start the engine and remove accumulated ca rbon from the ex -
hau st system by momentarily revving up the engine several
times.
Stop th e engine and reinstall the spark arrester.
NUTS, BOLTS, FASTENERS
T ig hten botts, nuts and fa stene rs 8t regular i ntervals shown in
the Maintenance Schedule [page 3- 21.
Check that all chassis nuts and bolts Bfa tightened 10 their COf -
re ct torque values (page 1-5). Check that all cotter pins and
safety clips are in place.
WHEELS/TIRES
Check the tires for cuts , embedded nails, or other sharp ob -
jects :
NOTE
•
Tire pressure should be chec ked when the tires are COLO.
Check the tire pressure.
TIRE PRESSURES:
Recommended pressure: 2 .2 psi 10 . 15 kg / cm
2
,
15 kPal
Minimum pressure: ' 86 : 1.9 psf 10 . 13 kg / em" , 13 kPaI
After '86: 1.7 psi 10 . 12 kg / em", 12 kpal
Maximum pressure: 2.6 psi 10 . 18 kg / em" , 18 kPal
Raise up the rear wheel and eheck the circu mferenc e of the
tires .
STANDARD TIRE CIRCUMFERENCE: 1, 285 mm 150.6 inl
MAINTENANCE
11) SPARK ARRESTER
3-13

Honda TRX70 Fourtrax 1986 Specifications

General

Brand	Honda
Model	TRX70 Fourtrax 1986
Category	Offroad Vehicle
Language	English