3 UCN Status Displays
3.4 Display Operation
190 HPM High-Performance Process Manager Service R688
Honeywell December 2020
3.4 Display Operation
Introduction
The following subsections describe the selection procedures for the UCN Status display, and its
associated displays. The status, statistics, and targets on the displays are also described.
UCN Status Displays
The UCN Status display is shown in the following figure. The display is obtained by selecting the
<SYST STATS> (System Status) key on the console and then selecting the PROCESS NETWORK
STATUS target on the display for the network you wish to examine.
Figure 97 UCN Status Display
To Next Page
Loading...
Need help?
General
