3 UCN Status Displays
3.4 Display Operation
196 HPM High-Performance Process Manager Service R688
Honeywell December 2020
CONTROL STATES Target
Selecting the CONTROL STATES command target on the UCN Status display in the following figure
invokes additional targets at the bottom of the display to change the control state of the UCN or the UCN
device chosen by its status box.
Figure 99 UCN Status Display – CONTROL STATES Target Selected
Not applicable for NIM
The CONTROL STATES target functions are not applicable when a NIM is chosen on the UCN Status
display.
To Next Page
Loading...
Need help?
General
