3 UCN Status Displays
3.4 Display Operation
194 HPM High-Performance Process Manager Service R688
Honeywell December 2020
LOAD/SAVE RESTORE Target
Selection of the LOAD/SAVE RESTORE command target on the UCN Status display invokes
additional targets at the bottom of the display either to load the personality program, restore the database,
or save the database for the UCN device chosen by its status box as shown in the following figure.
Figure 98 UCN Status Display – LOAD/SAVE RESTORE Target Selected
Not applicable for NIM
The LOAD/SAVE RESTORE target functions are not applicable when a NIM is chosen on the UCN
Status display.
Command targets
The command targets at the bottom of the display in Figure 98 perform the functions defined in Table 26
UCN Status Display – LOAD/SAVE RESTORE.
To Next Page
Loading...
Need help?
General
