To Next Page

To Previous Page

iManager NetEco 6000

Device Installation and Commissioning Guide

6 Adding Devices

Issue 03 (2019-03-10)

159

Table 6-11 Parameter description 2

Parameter

Setting

IP address

Set according to the actual plan.

Subnet mask

Set according to the actual plan.

Gateway

Set according to the actual plan.

----End

6.3.3.2 Creating an Smart Cooling Product on the NetEco

Prerequisites



You have logged in to the NetEco client.



You have the operation rights for Data Center Planning.



You have created a management domain for the device to be added on the Data Center

Planning page.

Procedure

Step 1 Choose Configuration > Configuration Management > Data Center Planning from the

main menu. The Data Center Planning window is displayed.

Step 2 Select the management domain to add a device.

Step 3 In the lower-left corner of the page, click the Device tab.

Step 4 Click the drop-down list box in Type and select Air Conditioner.

Step 5 Select the device to be added and drag its icon to the management domain.

To delete a device, click the device and choose Delete under .

Step 6 Specify parameters shown in Figure 6-28 in the right pane based on the following table. The

NetCol5000 complying with the MODBUS-TCP protocol is used as an example.

Huawei iManager NetEco 6000 User Manual

Questions and Answers: