To Next Page

To Previous Page

iManager NetEco 6000

Device Installation and Commissioning Guide

6 Adding Devices

Issue 03 (2019-03-10)

176

6.3.6.2 Creating a Power Module on the NetEco

Prerequisites



You have logged in to the NetEco client.



You have the operation rights for Data Center Planning.



You have created a management domain for the device to be added on the Data Center

Planning page.

Procedure

Step 1 Choose Configuration > Configuration Management > Data Center Planning from the

main menu. The Data Center Planning window is displayed.

Step 2 Select the management domain to add a device.

Step 3 If the management domain is a rack, DDF, or power cabinet, click the management domain

and choose Design under . The page for adding a device is displayed. Otherwise, skip this

step.

Step 4 In the lower-left corner of the page, click the Device tab.

Step 5 Click the drop-down list box in Type and select RPDU.

Step 6 Select the device to be added and drag its icon to the management domain.

To delete a device, click the device and choose Delete under .

Step 7 Specify parameters shown in Figure 6-40 in the right pane based on the following table. The

power module complying with the SNMP v3 protocol is used as an example.

Huawei iManager NetEco 6000 User Manual

Questions and Answers: