To Next Page

To Previous Page

iManager NetEco 6000

Device Installation and Commissioning Guide

3 Installing Devices

Issue 03 (2019-03-10)

Step 7 (Optional) Adjust the magnet.

1. If the magnet cannot attract the door properly after power-on, place a magnetized metal

part near the magnet to check whether the magnet provides a proper magnetic force.

2. If the magnetic lock and the magnet do not work properly, check and troubleshoot the

circuit.

----End

3.8.3 Installing an In-Room Single-Door Magnetic Lock

Context



Check that the room door is a single-door that can be rotated open outwards. The door

frame should be over 42 mm thick. A glass door is not supported.



The cable routes are planned.

Procedure

Step 1 Fold the delivered cutout template along the dotted line by 90°, as shown by (2) in Figure

3-50.

Step 2 Close the door, place the cutout template near the door top in the door opening direction,

mark the mounting holes, and drill holes, as shown in Figure 3-50.

Figure 3-50 Marking mounting holes

(1) Door frame

(2) Cutout template

(3) Door panel

Step 3 Remove the hoisting strip using the delivered hex key.

Huawei iManager NetEco 6000 User Manual

Questions and Answers: